Ferăstrău cu bandă - orizontal

BERG & SCHMID X-Rock 1250

1000 mm
1000 mm
1200x1000 mm
saw band length 11300 x 80 x 1,3 mm
table height 790 mm
band speed 14 - 60 m/min
Dwodpst Eacgefx Adijc
total power requirement 18 kW
weight of the machine ca. 9,0 t
dimensions 5,0 x 1,68 x 3,15 m
The semi-automatic, hydraulic saws from the X-tech line offer the best
Saw technology and best performance when cutting special steels
• The electro-welded machine frame and the steel saw frame meet requirements
all cutting needs and eliminate vibration and noise.
• The chip conveyor is hydraulically driven and the speed is
adjustable
• All movements of the machine (saw frame, vice, feed,
Saw band guides) are carried out thanks to modern linear guides with high
static and dynamic load performance, which also has very low sliding friction
to guarantee.
• Another characteristic feature is the roles for the
Positioning of the material by a hydraulic motor
are driven. They move at right angles to the material, and
thus allowing optimal clamping of the material.
• Thanks to the height control of the saw band position, the operator can place
the band in
place near the top edge of the material. After the cut is finished, the tape
automatically raised back to the previous position. Alternatively you can
also
“Remain” can be selected in the lower position. During the
The software compares the cutting load with the cutting cycle
Default. This means that the sawing system can be stopped in the event of
irregularities
become.
• The saw band is cleaned by two adjustable steel brushes. The drive
takes place hydraulically.
• The hydraulic unit including filter and pressure gauge guarantees one
particularly quiet operation at constant pressure.
• Finely ground carbide inserts that clamp the saw blade, complete with
lateral, hardened and adjustable guide rollers. The adjustable one
The tape guide automatically moves as close as possible to the material.
• The saw band is tensioned via a hydraulic cylinder, which is carried out by
the
Machine software is controlled. The voltage is set according to a given
Time automatically delimbed when the machine is idle or after
a cycle has been carried out.
• Automatic version with CNC control in the X-TECH 900 / 1200 models
a feed length of 500 mm for the series for high production rates.
• The material is carried by a table with seven rollers. These will
driven by a hydraulic orbital motor through which the material
can be placed precisely even under maximum load.
• All guided movements are carried out by four recirculating ball guides with
one
high capacity for static and dynamic loading; strong
reduced feed friction. Tempered and ground prismatic
Guides.
Price on request.