Hot-Chamber Diecasting Machine - Vertic.

FRECH DAW 80S

closing pressure 900 kN
clamping plate 540x540 mm
distance between columns 350x350 mm
weight of the machine ca. 5,5 t
lock stroke 280 mm
capacity of ejector 60 kN
ejector stroke 70 mm
height of form 160-400 mm
column diameter 65 mm
casting capacity 75 kN
casting plunger stroke 130 m/m
injection plunger diameter 50,55,60 mm
casting volume (DIN 24480) 119, 163, 214 cm 2
volume cast pressure 380, 315, 265 kp/cm²
casting area 236, 285, 340 cm 2
Traverse Stroke 150 m/m
General overhauled Die Casting machine DAW 80 GO with DataLogic control for the use of zinc alloys.
Excerpt from the overhaul:
· Upgrade of the machine with new control cabinet and operator panel
including new electric machine installation
· Renewal of the hydraulic system (blocks and valves)
Bwsdpfxeyzt D Es Afwjw
· locking unit overhaul
Details available upon request

The machine is equipped with the following options:
Front door motorized, rear door manual handling
Cover for drop through area at the subframe
Hanging operating desk with monitor
1.0.2 Cover for drop through area at the subframe with scale / chute
3.2.4 Multi-chamber furnace with pump TOC
3.2.1 furnace control cabinet
4.0.1 Hydraulic system for water glycol
6.1.3.1 Wired signal interface for extraction device (DISPO 010)
6.5.2 Equipment package, Remote Service Dialog (RSD) with switch
7.2.2.2 Spraymotion 611 E with servo drive
7.3.1 Lubricant container TD 20
7.4.0.3 Spray rail CR 275

Other options can be offered upon request